Longboard Bearings Set — 8-Pack Precision Skate Bearings

Sold by HighFiveSkateShop — Authorized Retailer. Original product by Loaded Boards.

This 8-pack of precision longboard bearings is built for riders who want consistent roll performance and low maintenance across extended use. The set includes eight bearings — enough to fully equip a standard four-wheel longboard setup with two bearings per wheel.

The bearings use a standard 608 form factor (8mm bore, 22mm outer diameter, 7mm width), which fits the axle diameter on the majority of longboard and skateboard trucks on the market. No adapters or spacers are required for most standard setups.

Each bearing uses a removable rubber shield on one side, which allows for cleaning and re-lubrication without disassembling the bearing completely. Riders who maintain their bearings regularly will find this design practical for extending service life, particularly in wet or dusty riding conditions where contamination is more likely.

The steel races and ball bearings are machined to ABEC-7 tolerances, which specifies the dimensional accuracy and running precision of the bearing. At this tolerance level, the bearings run smoothly at the speeds typical of longboard riding without generating excessive heat or noise from imprecision in the races.

Bearing spacers are included in the set. Spacers sit between the two bearings in each wheel and distribute axle load more evenly, which reduces lateral stress on the bearing races during hard turns and slides. Using spacers also makes wheel removal easier and reduces the risk of bearing damage when tightening axle nuts.

Specs:

• Quantity: 8 bearings (full set for one board)
• Form factor: 608 standard (8mm bore / 22mm OD / 7mm width)
• Tolerance: ABEC-7
• Shield: Removable rubber, one side
• Material: Steel races and balls
• Includes: Bearing spacers
• Age Group: Adult

Compatible with standard longboard and skateboard trucks with 8mm axles.